Napoleon-fireplaces GDIZC-P User Manual

1W415-0223 / D / 01.12.04INSTALLER: THESE INSTRUCTIONS MUST BE CONVEYED TO AND REMAIN WITH THE HOMEOWNER.Wolf Steel Ltd., 24 Napoleon Rd., Barrie, ON

10W415-0223 / D / 01.12.041. Turn off the electrical power and the gas supply to thefireplace insert.2. Remove the fire viewing door. Remove the logs.

11W415-0223 / D / 01.12.04Remove the pilot screw cap. Adjust the pilot screw to pro-vide properly sized flame. Turn in a clockwise direction toreduce

12W415-0223 / D / 01.12.0431* W690-0001 MILLIVOLT THERMOSTAT32* W660-0010 REMOTE CONTROL - ADVANTAGE32* W660-0011 REMOTE CONTROL - ADVANTAGE PLUS33* G

13W415-0223 / D / 01.12.04* WARNING: This is a fast acting thermocouple. It is an integral safety component. Replace onlywith a fast acting thermocou

14W415-0223 / D / 01.12.04Main burner goes out;pilot stays on.Pilot flame is not large enoughor not engulfing the thermopile.Thermopile shortingRemote

15W415-0223 / D / 01.12.04Exhaust fumessmelled in room,headaches.- check all seals. Fireplace is spilling.Carbon is being de-posited on glass,logs or

16W415-0223 / D / 01.12.04Wolf Steel Fireplace Service HistoryThis fireplace must be serviced annually depending on usage.DateService Technician Name

2W415-0223 / D / 01.12.04Pg 2-4 INTRODUCTIONWarrantyGeneral InstructionsGeneral InformationCare of Glass & Plated Parts5-7 INSTALLATIONInsert Vent

3W415-0223 / D / 01.12.04NAPOLEON gas fireplaces are manufactured under the strict Standard of the world recognizedISO 9001:2000 Quality Assurance Cer

4W415-0223 / D / 01.12.04FOR YOUR SATISFACTION, THIS FIREPLACE INSERTHAS BEEN TEST-FIRED TO ASSURE ITS OPERATIONAND QUALITY!Minimum inlet gas supply p

5W415-0223 / D / 01.12.04Provide adequate ventilation air.Provide adequate accessibility clearance forservicing and operating the fireplace insert

6W415-0223 / D / 01.12.04Move the insert close to its final position inside the wood-burning fireplace. This unit is equipped with 6 levellingscrews l

7W415-0223 / D / 01.12.04To adjust the trim: If the mitre is out of alignment, openeach side and loosen the two screws at either side trimhinge. Slide

8W415-0223 / D / 01.12.04Positioning the logs improperly will cause flame im-pingement and carboning.PHAZERTM logs and glowing embers, exclusiv

9W415-0223 / D / 01.12.04The on-off switch is located behind the left side controldoor.Purge all gas lines with the glass door open. Assurethat a