Napoleon-fireplaces Vector 50 - LHD50 User Manual Page 50
- Page / 136
- Table of contents
- TROUBLESHOOTING
- BOOKMARKS
Rated. / 5. Based on customer reviews
50
W415-0745 / F / 08.26.13
EN
EN
10.0 ADJUSTMENT
10.1 RESTRICTING VERTICAL VENTS
Adjust the pilot screw to provide properly sized fl ame. Turn in a
clockwise direction to reduce the gas fl ow.
Check Pressure Readings:
Inlet pressure can be checked by turning screw (A) counter-
clockwise 2 or 3 turns and then placing pressure gauge tubing
over the test point. Gauge should read as described on the chart
below. Check that main burner is operating on “HI”.
Outlet pressure can be checked the same as above using
screw (B). Gauge should read as described on the chart
below. Check that main burner is operating on “HI”.
AFTER TAKING PRESSURE READINGS, BE SURE TO
TURN SCREWS CLOCKWISE FIRMLY TO RESEAL. DO
NOT OVERTORQUE.
Leak test with a soap and water solution.
Prior to pilot adjustment, ensure that the pilot assembly
has not been painted. If overspray or painting of the pilot
assembly has occurred remove the paint from the pilot
assembly, or replace. Fine emery
cloth or sandpaper can be used to
remove the paint from the pilot hood,
electrode and fl ame sensor.
39.1C
A
B
PILOT SCREW
FLAME MUST ENVELOP
UPPER 3/8” (9.5mm) TO 1/2”
(12.7mm) OF FLAME SENSOR
PILOT
BURNER
ELECTRODE
FLAME
SENSOR
3/8” - 1/2”
(9.5mm - 12.7mm)
Pressure
Inlet
Outlet
Natural Gas
(inches)
Natural Gas
(millibars)
Propane
(inches)
Propane
(millibars)
7"
(MIN. 4.5")
3.5"
13"
(MIN. 11")
10"
17.4mb
(MIN. 11.2mb)
8.7mb
32.4mb
(MIN. 27.4mb)
24.9mb
10.2 PILOT BURNER ADJUSTMENT
77.3
Vertical installations may display a very active
fl
ame. I
f
this appearance is not desirable, the vent exit must
be restricted using a restrictor vent kit. Refer to “ACCESORIES” in the “REPLACEMENTS” section for the
appropriate kit. This will reduce the velocity of the exhaust gases, slowing down the fl ame pattern and creating
a more traditional gentle fl ame appearance. Specifi c instructions are included with the kit.
- INSTALLATION AND 1
- OPERATING INSTRUCTIONS 1
- TABLE OF CONTENTS 2
- 1.0 INSTALLATION OVERVIEW 3
- 2.0 INTRODUCTION 4
- 2.1 DIMENSIONS 5
- 2.2 GENERAL INSTRUCTIONS 6
- 2.3 GENERAL INFORMATION 7
- 2.5 SHIPPING HANDLES 9
- 3.0 VENTING 10
- W415-0745 / F / 08.26.13 11
- 3.3.1 PERISCOPE TERMINATION 12
- 3.8 HORIZONTAL TERMINATION 15
- ) > (V 16
- ) < (V 17
- 3.9 VERTICAL TERMINATION 17
- 4.0 INSTALLATION 19
- 4.1.1 HORIZONTAL INSTALLATION 20
- 4.1.2 VERTICAL INSTALLATION 20
- ROOF SUPPORT 23
- 4.3 MOBILE HOME INSTALLATION 24
- 2” (50.8mm) 25
- 20” (508mm) 25
- 5.0 FRAMING 26
- 67 7/8" 27
- 5.1 TWO SIDED APPLIANCE 28
- 5.2 ONE SIDE APPLIANCE 30
- STAND OFF 31
- SIDE VIEW 36
- 6.0 FINISHING 38
- Door Latch 39
- 6.2 GLASS MEDIA INSTALLATION 40
- 6.3 OPTIONAL ROCK PLACEMENT 41
- 6.4 LOGO PLACEMENT 41
- 6.5 UNIQUE INSTALLATIONS 41
- 7.0 ELECTRICAL CONNECTION 42
- ON REMOTE OFF 43
- 7.4 SCHEMATIC 44
- 8.0 OPERATION 45
- 8.4 TEMPERATURE DISPLAY 46
- 8.5 ROOM THERMOSTAT 46
- 8.6 SMART THERMOSTAT 46
- 8.7 FLAME HEIGHT 46
- 8.8 CHILD PROOF FUNCTION 47
- 8.12 CONTROL MODULE 48
- 8.14 TIMED BLOWER 48
- 9.0 OPERATING INSTRUCTIONS 49
- 10.0 ADJUSTMENT 50
- 10.3 VENTURI ADJUSTMENT 51
- 10.4 FLAME CHARACTERISTICS 51
- MAINTENANCE 52
- 11.2 CONTROL ACCESS 53
- 11.3 VALVE TRAIN ASSEMBLY 54
- 11.4 VALVE REMOVAL 54
- MEDIA TRAY 55
- 11.10 PORCELAIN WRAP 57
- 11.13 CARE OF GLASS 58
- 11.14 CARE OF PLATED PARTS 58
- 12.0 REPLACEMENTS 59
- ACCESSORIES 60
- HORIZONTAL TERMINAL KIT 60
- ROOF TERMINAL KITS 60
- 13.0 TROUBLESHOOTING 62
- SYMPTOM PROBLEM TEST SOLUTION 63
- 14.0 WARRANTY 65
- 15.0 SERVICE HISTORY 66
- Other Napoleon 68
- Products 68
- TABLE DES MATIÈRES 70
- 1.0 SURVOL DE L’INSTALLATION 71
- 2.3 INFORMATIONS GÉNÉRALES 75
- ÉVACUATION DIRECTE 78
- 3.3.1 ENSEMBLE PÉRISCOPIQUE 80
- 3.8 TERMINAISON HORIZONTALE 83
- 3.9 TERMINAISON VERTICALE 85
- W415-0745 / F / 09.13.13 100
- AVERTISSEMENT 102
- HAUT DE 104
- L’OUVERTURE 104
- DE L’APPAREIL 104
- 6.5 INSTALLATIONS UNIQUES 108
- 6.4 MISE EN PLACE DU LOGO 108
- (4) AA Batteries 110
- ON REMOTE OFF 110
- 8.4 AFFICHEUR DE TEMPÉRATURE 113
- 8.5 THERMOSTAT DE PIÈCE 113
- 8.6 THERMOSTAT SMART 113
- 8.7 HAUTEUR DE LA FLAMME 114
- 8.9 CRYSTALITES 114
- 8.12 MODULE DE CONTRÔLE 115
- 8.14 MINUTERIE DE SOUFFLERIE 116
- 10.0 RÉGLAGES 118
- 10.3 RÉGLAGE DU VENTURI 119
- 11.2 ACCÈS AUX CONTRÔLES 121
- PANNEAU D’ACCÈS DE 122
- PRÉINSTALLATION 122
- 11.5 ENLÈVEMENT DU BRÛLEUR 123
- CRYSTALITES 124
- DE PRISME 125
- ACCESSOIRES 128
- SYMPTÔME PROBLÈME SOLUTIONS 131
- CONDITIONS ET LIMITATIONS 133
- 15.0 HISTORIQUE D’ENTRETIEN 134
- 16.0 NOTES 135
- Autres produits Napoléon 136
Related products and manuals for Kiln Napoleon-fireplaces Vector 50 - LHD50
Kiln Napoleon-fireplaces GVF42 User Manual
(32 pages)
(32 pages)
Kiln Napoleon-fireplaces GVF36 User Manual
(28 pages)
(28 pages)
Kiln Napoleon-fireplaces EF30 User Manual
(48 pages)
(48 pages)
Kiln Napoleon-fireplaces EF30G User Manual
(49 pages)
(49 pages)
Kiln Napoleon-fireplaces EF39HD User Manual
(40 pages)
(40 pages)
Kiln Napoleon-fireplaces EFL72H User Manual
(48 pages)
(48 pages)
Kiln Napoleon-fireplaces EFL100 User Manual
(40 pages)
(40 pages)
Kiln Napoleon-fireplaces EF39S User Manual
(40 pages)
(40 pages)
Kiln Napoleon-fireplaces GSS48ST User Manual
(72 pages)
(72 pages)
© 2020, manymanuals.com. All rights reserved. | 1.200 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comments to this Manuals