Napoleon-fireplaces Vector 50 - LHD50 User Manual download pdf (Page 42)

W415-0745 / F / 08.26.13

If access to the control area is necessary BEFORE INSTALLATION, remove the pre-ﬁ nishing access panel.

The access panel must be re-installed before operating the appliance.

7.0 ELECTRICAL CONNECTION

Before ﬁ nishing in the appliance test the operation using the remote control, cycling it through all of its differ-

ent modes, see “OPERATION” section. Once ﬁ nished in, access to the control components can only be done

through the inside of the appliance.

NOTE: Control module ON/OFF switch should always be in the “ON” position. If for any reason the

module is turned “OFF”, the components plugged into the module won’t have power.

PRE-FINISHING

ACCESS PANEL

It is necessary to hard wire this appliance.

Permanently framing the appliance with an enclosure, requires the appliance junction box to be hard wired.

This appliance must be electrically connected and grounded in accordance with local codes. In the absence

of local codes, use the current CSA C22.1 Canadian electrical code in Canada or the ANSI/NFPA 70-1996

national electrical code in the United States.

7.1 HARD WIRING CONNECTION

WARNING

DO NOT USE THIS APPLIANCE IF ANY PART HAS BEEN UNDER WATER. CALL A QUALIFIED

SERVICE TECHNICIAN IMMEDIATELY TO HAVE THE APPLIANCE INSPECTED FOR DAMAGE TO THE

ELECTRICAL CIRCUIT.

RISK OF ELECTRICAL SHOCK OR EXPLOSION. DO NOT WIRE 110V TO THE VALVE OR TO THE

APPLIANCE WALL SWITCH. INCORRECT WIRING WILL DAMAGE CONTROLS.

ALL WIRING SHOULD BE DONE BY A QUALIFIED ELECTRICIAN AND SHALL BE IN COMPLIANCE

WITH LOCAL CODES. IN THE ABSENCE OF LOCAL CODES, USE THE CURRENT CSA22.1 CANADIAN

ELECTRIC CODE IN CANADA OR THE CURRENT NATIONAL ELECTRIC CODE ANSI/NFPA NO. 70 IN

THE UNITED STATES.

ALWAYS LIGHT THE PILOT WHETHER FOR THE FIRST TIME OR IF THE GAS SUPPLY HAS RAN OUT,

WITH THE GLASS DOOR OPENED OR REMOVED.

69.2

1 2 ... 37 38 39 40 41 42 43 44 45 46 47 ... 135 136

No comments

Napoleon-fireplaces Vector 50 - LHD50 User Manual Page 42