Napoleon-fireplaces Vector 45 - LHD45 User Manual download pdf (Page 24)

W415-0834 / E / 06.13.13

This appliance is also certiﬁ ed to be installed as an OEM (Original Equipment Manufacturer) installation

in a manufactured home (U.S. only) or mobile home and must be installed in accordance with the

manufacturer’s instructions and the Manufactured Home Construction and Safety Standard, Title 24 CFR,

Part 3280, in the United States or the Mobile Home Standard, CAN/CSA Z240 MH Series, in Canada. This

appliance is only for use with the type(s) of gas indicated on the rating plate.

29.1A

This Mobile/Manufactured Home Listed appliance comes factory equipped with a means to secure the unit. Built

in appliances are equipped with 1/4” (6.4mm) diameter holes located in the front left and right corners of the

base. Use #10 hex head screws, inserted through the holes in the base to secure. For free standing products

contact your local authorized dealer / distributor for the appropriate securing kit. For mobile home installations, the

appliance must be fastened in place. It is recommended that the appliance be secured in all installations. Always

turn off the pilot and the fuel supply at the source, prior to moving the mobile home. After moving the mobile home

and prior to lighting the appliance, ensure that the logs are positioned correctly.

This appliance is certiﬁ ed to be installed in an aftermarket permanently located, manufactured (mobile)

home, where not prohibited by local codes.

This appliance is only for use with the type of gas indicated on the rating plate. This appliance is not

convertible for use with other gases, unless a certiﬁ ed kit is used.

conversion kit is supplied with the mobile home appliance.

Conversion Kits

This appliance is ﬁ eld convertible between Natural Gas (NG) and Propane (LP).

To convert from one gas to another consult your Authorized dealer/distributor.

NOTE: All vent parameters are stated for rigid venting. If using approved Wolf Steel Ltd. ﬂ exible

venting then total horizontal lengths (H

) are reduced by 25%.

4.6 USING FLEXIBLE VENTING

4.7 MOBILE HOME INSTALLATION

4.8 REMOTE RECEIVER PLACEMENT

Position the remote receiver in the valve compartment close to the electrical junction box. Ensure the

receiver is on top of the placement label, if equipped.

35.25

PLACE REMOTE

RECEIVER ON TOP

OF THIS LABEL

FIREPLACE BASE

JUNCTION

BOX

1 2 ... 19 20 21 22 23 24 25 26 27 28 29 ... 119 120

No comments

Napoleon-fireplaces Vector 45 - LHD45 User Manual Page 24