Napoleon-fireplaces Vector 45 - LHD45 User Manual download pdf (Page 53)

W415-0834 / E / 06.13.13

13.0 TROUBLESHOOTING

SYMPTOM PROBLEM TEST SOLUTION

Pilot will not light.

Makes noise with

no spark at pilot

burner.

Wiring. - Verify the wire for the sensor and the wire for the

ignitor are connected to the correct terminals (not

reversed) on the module. NOTE: Sensor has 3/16”

(4.8mm) connection and ignitor has 1/8” (3.2mm)

connection.

Loose connection. - Verify no loose connections, electrical shorts in the

wiring or ground out to any metal object.

Module. - Turn the ON/OFF switch to the “OFF” position.

Remove the igniter wire from the module. Place

the ON/OFF switch to the “ON” position. Hold a

grounded wire about 3/16” (4.8mm) away from the

ignitor (spark) terminal on the module. If no spark

the ignitor terminal module must be replaced. If

there is a spark the ignitor terminal is ﬁ ne. Inspect

pilot assembly for a shorted wire or cracked

insulator around the electrode.

Igniter Spark gap is

incorrect.

- Spark gap of the ignitor to the pilot should be 1/8”

(3.2mm).

Transformer. - Verify the transformer is installed and plugged into

the module. Check voltage of the transformer under

load at the spade connections on the module with

the ON/OFF switch in the “ON” position. Acceptable

readings of a good transformer are between 6.2 and

7.0 volts A.C.

Battery backup (if power

is off)

- Check batteries.

A shorted or loose

Connection.

- Remove and reinstall the wiring harness that plugs

into the module. Remove and verify continuity of

each wire in wiring harness.

Improper switch wiring. - Troubleshoot the system with the simplest ON/OFF

switch.

Module is not grounded. - Verify the valve and pilot assemblies are properly

grounded to the metal chassis of the appliance or log set.

Pilot sparks but

will not light.

Gas supply. - Verify that the incoming gas line ball valve is “Open”.

Verify that the inlet pressure reading is within

acceptable limits, inlet pressures must not exceed

14” W.C. (34.9mb).

Out of propane gas. - Fill the tank.

SENSOR

IGNITOR

(SPARK)

PILOT TUBE

42.7A

WARNING

ALWAYS LIGHT THE PILOT WHETHER FOR THE FIRST TIME OR IF THE GAS SUPPLY HAS RAN OUT,

WITH THE GLASS DOOR OPEN OR REMOVED.

TURN OFF THE GAS AND ELECTRICAL POWER BEFORE SERVICING THE APPLIANCE.

APPLIANCE MAY BE HOT, DO NOT SERVICE UNTIL APPLIANCE HAS COOLED.

DO NOT USE ABRASIVE CLEANERS.

1 2 ... 48 49 50 51 52 53 54 55 56 57 58 ... 119 120

Comments to this Manuals

No comments

Napoleon-fireplaces Vector 45 - LHD45 User Manual Page 53

Comments to this Manuals

Related products and manuals for Kiln Napoleon-fireplaces Vector 45 - LHD45