Napoleon-fireplaces Vector 45 - LHD45 User Manual download pdf (Page 47)

W415-0834 / E / 06.13.13

11.2 ANNUAL MAINTENANCE

37.1A

WARNING

THE FIREBOX BECOMES VERY HOT DURING OPERATION. LET THE APPLIANCE COOL

COMPLETELY OR WEAR HEAT RESISTANT GLOVES BEFORE CONDUCTING SERVICE.

NEVER VACUUM HOT EMBERS.

DO NOT PAINT THE PILOT ASSEMBLY.

• This appliance will require maintenance which should be planned on an annual basis.

• Service should include cleaning, battery replacement, venting inspection and inspection of the burner,

media and ﬁ rebox. Refer to the door removal section and remove the door as instructed.

• Carefully remove media if necessary (logs, glass, brick panels etc).

• Using a vacuum with a soft brush attachment, gently remove any dirt, debris or carbon build up from the

logs, ﬁ rebox and burner. For glass media, follow the installation instructions for pre-cleaning.

• Also gently remove any build-up on the pilot assembly including, if equipped; thermopile, thermocouple,

ﬂ ame sensor and igniter. NOTE: The ﬂ ame sensor may require to be cleaned with an abrasive, such

as emery cloth, to remove any oxides. It is important that the pilot assembly is not painted.

• Inspect all accessible gaskets and replace as required.

• Access the blower, if equipped and clean using a soft brush and vacuum.

• Re-assemble the various components in reverse order.

• Inspect the relief system. The appliance relief through the main glass door or through the ﬂ aps on the

ﬁ rebox top. Ensure they open freely, and close sealed.

11.1 GLASS / DOOR REPLACEMENT

WARNING

DO NOT USE SUBSTITUTE MATERIALS.

GLASS MAY BE HOT, DO NOT TOUCH GLASS UNTIL COOLED.

CARE MUST BE TAKEN WHEN REMOVING AND DISPOSING OF ANY BROKEN DOOR GLASS OR

DAMAGED COMPONENTS. BE SURE TO VACUUM UP ANY BROKEN GLASS FROM INSIDE THE

APPLIANCE BEFORE OPERATION.

DO NOT STRIKE, SLAM OR SCRATCH GLASS. DO NOT OPERATE APPLIANCE WITH GLASS

REMOVED, CRACKED, BROKEN OR SCRATCHED.

56.2

A. Place the door frame face down careful not to scratch the

paint.

B. Center the gasketed glass inside the door frame with the thick

side of the gasket facing up.

C. Bend the glass retainers located along the edge of the door

frame over the gasket holding the glass in place. Be careful

not to break the glass.

GLASS

RETAINERS

GASKET

DOOR

FRAME

GLASS

1 2 ... 42 43 44 45 46 47 48 49 50 51 52 ... 119 120

Comments to this Manuals

No comments

Napoleon-fireplaces Vector 45 - LHD45 User Manual Page 47

Comments to this Manuals

Related products and manuals for Kiln Napoleon-fireplaces Vector 45 - LHD45

Produits connexes et manuels pour Lave-vaisselle Küppersbusch IG6504.0E