Napoleon-fireplaces Vector 45 - LHD45 User Manual download pdf (Page 54)

W415-0834 / E / 06.13.13

SYMPTOM PROBLEM TEST SOLUTION

Carbon is being

deposited on

glass, logs,

rocks, media

or combustion

chamber surfaces.

Air shutter has become

blocked.

- Ensure air shutter opening is free of lint or other

obstructions.

Flame is impinging on the

glass, logs, rocks, media

or combustion chamber.

- Check that the glass, logs, rocks or media are

correctly positioned.

- Open air shutter to increase the primary air.

- Check the input rate: check the manifold pressure

and oriﬁ ce size as speciﬁ ed by the rating plate

values.

- Check that the door gasketing is not broken or

missing and that the seal is tight.

- Check that both vent liners are free of holes and

well sealed at all joints.

- Check that minimum rise per foot has been adhered

to for any horizontal venting.

Continues to

spark and pilot

lights, but main

burner will not

light.

Short or loose

connection in sensor rod.

- Verify all connections. Verify the connections

from the pilot assembly are tight; also verify these

connections are not grounding out to any metal.

Poor ﬂ ame rectiﬁ cation

or contaminated

sensor rod.

- Verify the ﬂ ame is engulﬁ ng the sensor rod. This

will increase the ﬂ ame rectiﬁ cation. Verify correct

pilot oriﬁ ce is installed and inlet gas speciﬁ cations

to manual. (Remember, the ﬂ ame carries the

rectiﬁ cation current, not the gas. If the ﬂ ame lifts

from pilot hood, the circuit is broken. A wrong oriﬁ ce

or too high of an inlet pressure can cause the pilot

ﬂ ame to lift.) The sensor rod may need cleaning.

Poor grounding between

pilot assembly and

gas valve.

- Verify that the wire harness is ﬁ rmly connected to

module Verify that the ceramic insulator around the

sensor rod is not cracked, damaged, or loose. Verify

the connection from the sensor rod to the sensor wire.

Damaged pilot or dirty

sensor rod.

- Clean sensor rod with an emery cloth to remove

any contamination that may have accumulated on

the sensor rod. Verify continuity with multimeter with

ohms set at the lowest range.

Pilot lights

Stops sparking

/ pilot remains lit

but burner will

not turn on.

Wiring / Connection. - Inspect all wires, ensure good tight connections.

Verify that all wiring is installed exactly as speciﬁ ed.

Wiring harness. - Inspect the wiring harness, and verify the harness

is tightly connected to the module. Verify that all

wires are connected in the right order. See “WIRING

DIAGRAM” section.

Exhaust fumes

smelled in room,

headaches.

Appliance is spilling. - Check all seals.

- Check if exhaust is re-entering through an open

door or window.

42.7_2

1 2 ... 49 50 51 52 53 54 55 56 57 58 59 ... 119 120

Comments to this Manuals

No comments

Napoleon-fireplaces Vector 45 - LHD45 User Manual Page 54

Comments to this Manuals

Related products and manuals for Kiln Napoleon-fireplaces Vector 45 - LHD45